ArcadeNanoColourEnglish: Difference between revisions
From BlinkenArea Wiki
ArneRossius (talk | contribs) No edit summary |
ArneRossius (talk | contribs) No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 32: | Line 32: | ||
* [[:Image:ANC_rev1.0_schematic.png|Schematic Rev. 1]] (PNG-Grafik) | * [[:Image:ANC_rev1.0_schematic.png|Schematic Rev. 1]] (PNG-Grafik) | ||
* [[:Media:ANC_rev1.0.zip|PCB layout Rev. 1]] (Gerber files) - 4 copper layers with blind vias | * [[:Media:ANC_rev1.0.zip|PCB layout Rev. 1]] (Gerber files) - 4 copper layers with blind vias, includes stencil data (GTP/GBP) | ||
* [[:Media:ANC_rev1.0-instructions.pdf|Construction kit instructions Rev. 1.0]] for PCB Rev. 1.0 | * [[:Media:ANC_rev1.0-instructions.pdf|Construction kit instructions Rev. 1.0]] for PCB Rev. 1.0 | ||
| Line 39: | Line 39: | ||
This project uses the [[BlinkenPlusEnglish|BlinkenPlus]] firmware. | This project uses the [[BlinkenPlusEnglish|BlinkenPlus]] firmware. | ||
== | == Photos == | ||
More photos at http://arne.blinkenarea.org/ArcadeNano%20Colour/gallery.htm. | More photos at http://arne.blinkenarea.org/ArcadeNano%20Colour/gallery.htm. | ||
Latest revision as of 18:40, 31 March 2024
project overview  | |
| |
| Year | 2019 |
| Number of pixels | 520 |
| Grayscales / Colors | 512 |
| Illuminant | SMD LEDs (1x1 mm) |
| Power input | ? W |
| Contact person | Arne Rossius |
| Project website | |
ArcadeNano Colour is the colour version of ArcadeNano. It is powered through a Mini-USB jack.
Unlike the monochrome version, there is no lighium polymer battery as the circuit requires exactly 5 V due to the RGB LEDs, and there was no space left on the circuit board for a voltage converter. An external 5 V supply can be connected to the "Ext" solder pads on the bottom of the circuit board. The on/off switch then switches between USB and "Ext" supply.
Features
- 26x20 = 520 pixels, aspect ratio 1:2
- MicroSD card
- MCUF stream through a virtual serial port via USB (CH340C)
- 115200 Baud (max. 7.3 fps)
- Stream output for all displayed frames (from microcontroller flash memory, SD card or incoming stream)
- Power supply:
- USB (5V), max. ??? mA
Hardware
- Schematic Rev. 1 (PNG-Grafik)
- PCB layout Rev. 1 (Gerber files) - 4 copper layers with blind vias, includes stencil data (GTP/GBP)
- Construction kit instructions Rev. 1.0 for PCB Rev. 1.0
Software
This project uses the BlinkenPlus firmware.
Photos
More photos at http://arne.blinkenarea.org/ArcadeNano%20Colour/gallery.htm.
