DuckMiniEnglish

project overview
Year	2019
Number of pixels	34
Grayscales / Colors	8 grayscales
Illuminant	SMD LEDs
Power input
Contact person	Arne Rossius
Project website

The DuckMini is the SMD version of the THT Duck. The circuit and software are mostly identical, but for cost reasons the ATmega8 microcontroller was replaced with an ATtiny88 which is only available in an SMD package. More detailled information about the circuit and software can be found on the Duck project page.

Hardware

The circuit is identical to the full-size duck except for the microcontroller. Instead of the loose battery holder for 3 AA cells, this version uses a soldered-down holder for 3 AAA cells on the bottom side of the PCB. It is recommended to also stick a piece of double-sided foam tape (mirror mounting tape) in the corner opposite the battery holder's pins. Above the battery holder, the PCB is just large enough to provide space for the large tantalum capacitor and an ISP pin header.

Instead of using the large battery holder, the PCB also provides a footprint for a CR2032 button cell holder. Due to the lower voltage and the large internal resistance of the button cell, the quacking of the duck will be very quiet and the LEDs will be dimmer, but for a duck without sound which won't be turned on for days at a time, the button cell is still a good option.

Rev. 1.0

• Schematic (PNG)
• Schematic (EAGLE 4.x)
• PCB layout (EAGLE 4.x)
• Kit instructions Rev. 1.0 for PCB Rev 1.0

Software

• Firmware version 2019-05-01

Photos

More photos at http://arne.blinkenarea.org/duck-mini/gallery.htm.