TicTacLightsEnglish

From BlinkenArea Wiki
Revision as of 17:04, 27 December 2013 by ArneRossius (talk | contribs)
Jump to: navigation, search
project overview
Zur deutschsprachigen Version dieser Seite
Tictaclights-operating-crop.jpg
Year 2012
Number of pixels 144
Grayscales / Colors 8 Grayscales
Illuminant SMD LEDs (size 0805)
Power input 200 mW
Contact person Arne Rossius
Project website

The TicTacLights is a very small BlinkenLights clone which fits inside a small TicTac box. It is powered by a CR2032 button cell battery. Battery life is only about 30 minutes, alternatively a lithium-polymer battery with an additional voltage regulator can be used.

This project uses the BlinkenPlus firmware on an ATmega8515 controller. The PCB has pads for a Micro-SD card slot and solder pads for a serial port (with external level converter, e.g. MAX3232).

The kit sold at 29C3 has a wrong setting for the low fuse byte. The correct setting is 0xFF (all bits not programmed). The fuse bytes can be changed with an AVR programmer and an external 5V supply (remove SD card before applying power!).

Hardware

The hardware is kept very simple because there isn't a lot of space on the PCB. The columns are directly connected to the controller's outputs, so large currents are not possible. Due to the high internal resistance of the button cell battery, the voltage drops quickly, causing the controller and the SD card to operate outside of their specifications (which requires a minimum voltage of 2.7 V).

Rev. 3

Powered by USB or lithium-ion battery. Button cell holder removed.

Rev. 2

Can be powered by USB or button cell.

Rev. 1

Alternative Power Supplies

Photos

http://arne.blinkenarea.org/TicTacLights/gallery.htm