BlinkstroemColourEnglish: Difference between revisions

From BlinkenArea Wiki
Jump to: navigation, search
No edit summary
No edit summary
Line 28: Line 28:


With additional resistors to reduce ghosting.
With additional resistors to reduce ghosting.
* [[:Image:Bsc-rev1.1.png|Schematic]]
* [[:Image:BSC-rev1.1.png|Schematic]]
* [[Media:BSC-rev1.1.sch|Schematic]] (EAGLE file, version 4.16)
* [[Media:BSC-rev1.1.sch|Schematic]] (EAGLE file, version 4.16)
* [[Media:BSC-rev1.1.brd|PCB layout]] (EAGLE file, version 4.16)
* [[Media:BSC-rev1.1.brd|PCB layout]] (EAGLE file, version 4.16)

Revision as of 18:00, 27 December 2013

project overview
Zur deutschsprachigen Version dieser Seite
Bsc colours crop.jpg
Year 2013
Number of pixels 144
Grayscales / Colors RGB, 83 = 512 colours
Illuminant SMD LEDs
Power input 4 W
Contact person Arne Rossius
Project website

Blinkström Colour is a BlinkenLights clone that can display full colour animations.

This project uses the BlinkenPlus firmware on an ATmega162 controller. On the PCB there is an SD card slot as well as a level converter and solder pads for an RS232 serial port for streaming input and output.

Attention! The kit instructions from OHM2013 have the wrong capacitor identifiers. A corrected version is available for download below.


Hardware

The LED matrix is divided into 18 columns and three times 8 rows (8 each for red, green and blue). The multiplexing is going across the columns from right to left, so only one column is lit at a time. The refresh rate is 100 Hz for the lowest brightness level and increases for the higher brightness levels. The board has to be supplied from an external 5 V power supply capable of at least 0.8 A.

The 3.3 V power supply for the SD card is generated either by two silicon diodes in series or a 3.3 V regulator. If the diodes are used, C10A (100 nF) is populated, for the voltage regulator C10B (1 µF) is necessary. R38D is a basic load to prevent the voltage from becoming too high when no SD card is inserted, especially when using the diodes.

Rev. 1.1

With additional resistors to reduce ghosting.

Rev. 1.0

Animations

Unfortunately, only very few colour animations are available. If you create your own animations (e.g. using Blimp), you are very welcome to send them in. For now, some animations are available here: Full colour BlinkenLights animations.

Photos

More photos: http://arne.blinkenarea.org/BlinkstroemColour/gallery.htm